Whipping cream machines
machine cleaning
1 - 2
burst view
REcipes
air regulator cleaning
pump lid assembling
1 - 2
AIR REGULATOR

1 - Dismantle the 3 distinct pieces 

2 - Clean each pieces (hot water + detergent)

3 - Use a bottle brush and a metal rod (stainless steel).

1 - Bottom of the slot from above .

- Stainless steel must clearly appears at the bottom of the slot.

- Central hole must be visible.

- The side hole appears.

1 - Bottom of the slot from below.

- Stainless steel must clearly appears at the bottom of the slot.

- Central hole must be visible

1 -Slot from the side.

- With a small metal rod, check that the air entrance hole is not blocked .

1 - Base

- The 7 little holes must be visible .

- The spring must let appears the central axis.

- Stainless steel must be free of movement.

1 - Reassemble the 3 elements tightened moderatly.

- Once you have the mark stops ,put it between 2 and 3.

- Replace it on the machine.

- According to the cream ,make adjustments.

- Never make more than one round; in contrary case the air regulator is probably blocked or the defective cream .

NB :Never make more than one round; in contrary case the air regulator is probably blocked or the defective cream .
978 Avenue du 2ème Cuirassiers
13420 GEMENOS

TEL : 04 91 79 12 19
FAX : 04 42 62 94 16

 

AFTER SALES SERVICE ON EVERY BRANDS - FREE ESTIMATES.
www.machineachantilly.com